How to Clean an enDAQ sensor for re-calibration

Clean Unit: Please remove any residue from your enDAQ sensor to ensure a smooth re-calibration process.

Important: Please ensure your device’s mounting surface is clean prior to sending them in. The devices must be free of sticky residue or any other materials that could interfere with the mounting surface, and as a result, the recalibration process.

We recommend using the plastic scraper blades you received with your device, an adhesive eraser wheel, or a liquid adhesive remover. Make sure you DON’T USE ACETONE on polycarbonate devices as it will deform the enclosure and could negatively impact your accelerometer readings.

A  $100 Cleaning Fee per unit will be incurred for devices that are not adequately cleaned for re-calibration.

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.